Home
Brands
Lubricant FlowLUB 2000
  • Lubricant FlowLUB 2000

Lubricant FlowLUB 2000, 12 btl. box

FL2000
Fremco

Special lubricant for fiber cable and micro cable installation. 

Lubrication (FlowLUB) are water-based lubricants for all ducts and cables. The lubrication greatly reduces friction and static electricity.

FOR POWERFLOW and MULTIFLOW

Description

Great improvement of blowing length 

It is a water-based product with high lubricating effect. It greatly reduces friction and static electricity. 

Easy to apply

The lubrication spreads evenly on the cable surface/inner wall of the duct. It leaves a very thin film of lubricant and does not make a glue effect.

Low cost

The lubrication is very concentrated, meaning it is very economical to use. 

PRODUCT USE

Cable and duct prelubrication.

Shake the bottle before use and apply the lubricant in the duct. Place a suitable sponge in the duct and prelubricate the duct with high pressure air.

RECOMMENDED QUANTITY PER 1,000 M:

Duct OD 20-30 mm - 60 ml

Duct OD 30-40 mm - 70 ml

Duct OD 40-50 mm - 100 ml 

Sharp turns, loops or long blowing lengths will increase the recommended quantity required.

Product Details
FL2000

Data sheet

Aspect
White liquid tiny viscosity
Odour
None
Viscosity
120 sec. 4 mm Ford cup at 20°C
Gravity
1.030 +/- 0.03 gr/cm3
PH value
7.5 +/- 0.5
Inflammability
Non flammable
Temperature
From 0°C to + 70°C
Biodegradability
Biodegradable
Toxic
Non-toxic
Type of product
Lubrication
Attachments
Download
Lubricant FlowLUB Datasheet

Lubricant FlowLUB Datasheet, English

Download (290.57KB)
Comments (0)
Grade
No customer reviews for the moment.
16 other products in the same category:
X-Block Quick view

Reference: 103-10352

Brand: Fremco

X-Block

(0)
The X-block is used for adding one cable to an existing duct with two cables inside. The x-block has a fixed 40 mm connection at one end and in the other end a 50 mm fixed connection.
More
Y-Block Quick view

Reference: 103-201112003

Brand: Fremco

Y-Block

(0)
The flexible Y-block, normally used for overblow, can assist you in adding one cable to an existing duct where another cable is already installed.
More
Mini Y-block Quick view

Reference: KA60500-40

Brand: Fremco

Mini Y-block

(0)
This small Mini Y-block is a perfect supplement to your fiber blowing equipment. It creates an easier workday as it can fit into existing handholes.
More
Valve for reverse airflow Quick view

Reference: 103-20603

Brand: Fremco

Valve for reverse airflow

(0)
When a fiber/cable must be removed from a microduct due to damage/fault, the valve for reverse airflow is used. It is mounted at the end of the microduct, and when compressed air is connected, the fiber comes out by itself.
More
Fiberstop end kit Quick view

Reference: 103-20601

Brand: Fremco

Fiberstop end kit

(0)
The fiber stop is a safety system that can be reused to stop the fiber when it arrived at the intended end point. This makes it possible to perform fiber blowing installations with one technician.
More