Mini Blowing Junction Block Kit
  • Mini Blowing Junction Block Kit
  • Mini Blowing Junction Block Kit
  • Mini Blowing Junction Block Kit

Mini Blowing Junction Block Kit

103-180314001
Fremco

The Mini Blowing Junction Block is the perfect accessory for any fiber blowing engineer.

Description

The Fremco mini blowing junction block is originally developed for straightening a cable when blowing in two directions, and there is a loop left because the regular blowing machine does not fit into the manhole. 

It can also be used to blow a cable (by hand in short distances) from a narrow spot where there is no room for a regular blowing machine or as a low cost hand held fiber blowing device.

It is made from surface treated aluminum and can withstand the air pressure being used in any fiber network. It uses the same type/size of seals as the Fremco Miniflow RAPID.

 

Mini Blowing Junction Block Kit

Item No.: 103-180314001 

The kit contains: 

  • 1 pcs Mini blowing junction block (manual cable blowing into 8-12 mm microducts) 
  • 2 pcs cable seals in all sizes between 3 to 7.5 mm. 
  • 1 pcs Allen key 
  • 1 pcs 12-8 mm reducer 
  • 1 pcs 12-10 mm reducer
  • 2 pcs of 12 mm microduct
Product Details
103-180314001

Data sheet

Type of product
Air accessories
Comments (0)
Grade
No customer reviews for the moment.
16 other products in the same category:

Reference: 103-201112003

Brand: Fremco

Y-Block

(0)
The flexible Y-block, normally used for overblow, can assist you in adding one cable to an existing duct where another cable is already installed.

Reference: K02S

Brand: Fremco

Blowing tips

(0)
The fiber blowing tips prevents air getting into the cable that is being blown, avoiding air reaching the cable drum. It provides weight to small fibers, making it easier to fiber blow.

Reference: FL2000

Brand: Fremco

Lubricant FlowLUB 2000, 12 btl. box

(0)
Special lubricant for fiber cable and micro cable installation.  Lubrication (FlowLUB) are water-based lubricants for all ducts and cables. The lubrication greatly reduces friction and static electricity. FOR POWERFLOW and MULTIFLOW

Reference: 103-20601

Brand: Fremco

Fiberstop end kit

(0)
The fiber stop is a safety system that can be reused to stop the fiber when it arrived at the intended end point. This makes it possible to perform fiber blowing installations with one technician.
You might also like

Reference: 101-10031

Brand: Fremco

MiniFlow Rapid

(0)
Hydraulic cable blowing machine with a built-in electronic counter and cable damage safety monitoring system. Fiber/Cable OD: 3-12 mm; Duct size OD: 7-20 mm; Preparation time: 4 min; Blowing distance: up to 3 500 m.